Complete self-supporting gate automation kit PNI AP800C, motor, wheels, photocells, remote control, lamp, 6 meter rack, 2x3 m rail for a useful opening of 4-5 m, 230V, 1100 N and 800KG sliding gate

Self-supporting gate automation system

The self-supporting gate opening automation kit is equipped with a 350W motor that can open or close gates with a maximum weight of 800 kg. The PNI AP800C gate automation kit includes all the components necessary to put a practical access control system into operation: the motor, warning lamp, two photocells, 6 meters of rack, wheel kit and mounting accessories kit

Remote control

The gate can be opened and closed from the remote control or other access control devices such as access buttons or access keyboards can be connected to the system.

Obstacle detection

To avoid accidents, two levels of sensitivity can be set: high and low. If the gate is closing or opening and encounters an obstacle, the motor will stop.

Automatic closing

It is possible to program the automatic closing of the gate after a certain number of seconds (10, 30 or 60). Condominium mode can also be programmed which allows simultaneous control from multiple access devices. In condominium mode, when the gate is opening, if you press the buttons on the remote control or on another connected access terminal (access button or access keyboard), they will not work until the gate is fully open. When the gate is closing, if the buttons on the remote control or another connected access terminal are pressed, the gate will stop and open completely allowing access.

Warnings in assembly

Do not weld when:

- this is mounted on the bearing sets (the contact of the bearings is damaged);

- the motor is mounted (it leads to failure of the board and the wiring on it).