PNI AP800D gate automation kit includes motor, photocells, remote control, lamp, 230V develops 1100 N and 800KG sliding gate

Self-supporting gate automation motor

The motor has a power of 350W and can open or close gates with a maximum weight of 800 kg.

The PNI AP800D gate automation kit, which includes this motor, contains all the components necessary to automate a self-supporting gate: the motor, the warning lamp, two photocells and mounting accessories.

Local and remote control

The gate can be opened and closed from remote control (2 remote controls included) or other access control devices such as access buttons, access keypads, card readers, smart relays with internet control, etc. can be connected.

Obstacle detection and incident prevention

To avoid incidents, the obstacle detection sensitivity level can be set from low to high. If the gate is closing or opening and encounters an obstacle, the motor will stop.

Also the set of photocells included in the package detects any obstacle occurring or present in the gate opening and automatically stops the motor, respectively the gate closing.

Automatic closing

You can program the gate to close automatically after a certain number of seconds (10, 30 or 60). You can also program condominium mode which allows simultaneous control from multiple access devices.

In condominium mode, when the gate is opening, pressing the buttons on the remote control or other connected access terminal (access button or access keypad) will not operate until the gate is fully open. When the gate is closing, pressing the buttons on the remote control or other connected access terminal will stop the gate and open the gate fully allowing access.

Installation cautions

Do not weld when:

- it is mounted on the bearing sets (bearing contact is damaged);

- the motor is mounted (leads to damage to the plate and the wiring harness on it).