PNI AP800D gate automation kit, motor, photocells, remote control, lamp, 230V, 1100 N and 800KG sliding gate

Self-supporting gate automation motor

The motor has a power of 350W and can open or close gates with a maximum weight of 800 kg.

The PNI AP800D gate automation kit, which includes this motor, contains all the components needed to automate a self-supporting gate: the motor, the warning lamp, two photocells and mounting accessories.

Local and remote control

The gate can be opened and closed by remote control (2 remote controls included) or other access control devices such as access buttons, access keypads, card readers, smart relays with internet control, etc. can be connected.

Obstacle detection and incident prevention

To avoid incidents, the level of obstacle detection sensitivity can be set: from low to high. If the gate is closing or opening and encounters an obstacle, the motor will stop.

Also, the set of photocells included in the package detects any obstacle that appears or is present in the gate opening and automatically stops the motor, respectively the closing of the gate.

Automatic closing

It is possible to program the automatic closing of the gate after a certain number of seconds (10, 30 or 60). Condominium mode can also be programmed which allows simultaneous control from multiple access devices.

In condominium mode, when the gate is opening, if the buttons on the remote control or other connected access terminal (access button or access keypad) are pressed, they will not work until the gate is fully open. When the gate is closing, if the buttons on the remote control or other connected access terminal are pressed, the gate will stop and open fully allowing access.

Warnings in assembly

Do not weld when:

- this is mounted on the bearing sets (the contact of the bearings is damaged);

- the motor is mounted (it leads to failure of the board and the wiring on it).