PNI KAP800D self-supporting gate automation kit, motor, photocells, remote control, lamp, 230V, 1100 N and 800KG sliding gate

Self-supporting gate automation motor

The motor has a power of 350W and can open or close gates with a maximum weight of 800 kg.

The PNI KAP800D gate automation kit, with which this motor is compatible, includes all the components necessary for the commissioning of a practical access control system: the motor, the warning light, two photocells and mounting accessories.

Remote control

The gate can be opened and closed from the remote control (2 remote controls included) or other access control devices such as access buttons or access keypads can be connected.

Obstacle detection

To avoid accidents, two sensitivity levels can be set: high and low. If the gate is closing or opening and encounters an obstacle, the engine will stop.

Automatic closing

The automatic closing of the gate can be programmed after a certain number of seconds (10, 30 or 60). One can also program the condominium mode that allows simultaneous control from multiple access devices.

In condominium mode, when the gate is in open, if the buttons on the remote control or other connected access terminal (access button or access keypad) are pressed, they will not operate until the gate is fully opened. When the gate is closing, if the buttons on the remote control or other connected access terminal are pressed, the gate will stop and open fully allowing access.

Warnings in assembly

Do not perform welds when:

- it is mounted on the bearing sets (the bearing contact is damaged);

- the motor is mounted (leads to the failure of the board and the wiring on it).